MIDLAND CT 200_400 - Manual (Page 17)

E
N
G
L
IS
H
7
Self-Programming mode
To enter in Self-Programming mode, follow these steps:
.. while.turning.on.the.unit,.hold.down.‘ MONI’.and. .until.‘SELF’.is.displayed;
2.. press. ;
3.. turn.the. Encoder knob and select the memory number to program;
4. push .again;
5.. digit.the.desired.rx.frequency;
6.. press. ;
7.. press. .and.with.the. Encoder knob select the desired CTCSS in RX (if you
press it again, you can select a DCS code);
8.. press. ;
9.. digit.the.desired.tx.frequency;
0..push. ;
..press. .and.with.the. Encoder knob select the desired CTCSS in TX (if you
press it again, you can select a DCS code);
2..press. ;
3..with. the. Encoder knob, enable/disable the busy channel lockout (you can
choose: OFF, 1 carrier, 2 CTCSS/DCS);
14. press ;
5..by. turning. the. Encoder knob, you can enable/disable the priority channel
scanning;
6..press. ;
7..turn.the. Encoder knob and select the power level in tx H (high) or L (low);
8..press. ;
9..turn. the. Encoder knob and select the transmission mode: WIDE or
NARROW;
20..push. ;
2..rotate. the. Encoder knob and select the first letter for the name of the
programmed.channel..To.switch.to.the.next.channel,.push.the.. .button.
and.turn.the. Encoder knob;
22..press. ;
23. switch off the unit to finish the programming procedure and return to the
standard.modality..