MIDLAND CT 200_400 - Manual (Page 13)

E
N
G
L
IS
H
3
To select the repeater shift you can use the fast menu: press
the.
key and then .and.follow.the.procedure.above.
described.starting.from.point.3.
Repeater shift adjustment
(for communications through repeaters)
..press.the. .button;
2..turn. the. Encoder knob until ‘DIFFR’ (menu 15) is
displayed
3..push. ;
4. turn the Encoder knob and select the repeater shift. You
can.also.enable.it.by.digiting.the.frequency.directly.on.the.
keypad.
5..press. ;
Select the frequency step
..press.the. .button;
2..turn.the. Encoder knob until ‘STEP’ (menu 20) is displayed
3..push. ;
4. turn the Encoder knob and select the desired frequency
step. You can choose amongst: 5 KHz, 10 KHz, 6.25 KHz,
12.5 KHz and 25 KHz;
5..press.twice.the. knob to exit
Select the CTCSS and DCS tones
To select a CTCSS tone
..press.the. .button;
2..turn. the. Encoder knob until ‘C-CDC’ (menu 16) is
displayed
3..push. ;
4. turn the Encoder knob and select the desired subaudio
tone;
5..press. to confirm.
To select a DCS tone:
..select.‘C-CDC’ (menu 16) either with the Encoder knob or
with.the.fast.access;
2..Press.
3..Press.the. .button;
4. turn the Encoder knob and select the desired DCS level;
5..press. again for confirmation.