MIDLAND CT 200_400 - Manual (Page 12)

E
N
G
L
IS
H
2
the. key and then .and.follow.the.procedure.above.
described.starting.from.point.3.
Beep on/off
The keypad beep is activated by default. To deactivate it:
..press.the.
.button;
2..turn.the. Encoder knob until ‘BEEP’ (menu 09) is displayed
3..push. ;
4. turn the Encoder knob and activate/deactivate the beep
(ON = beep enabled; OFF = beep disabled);
5..press. ;
6..press.twice.the. knob to exit.
To activate/deactivate the keypad beep, you can use the
fast menu: press the
key and then .and.follow.the.
procedure.above.described.starting.from.point.3.
Automatic Numbering Identification
(ANI) on/off
You can set an automatic number identifier visible from the
radio’s.display.of.your.partner.each.time.you.send.a.call.signal..
To activate this function:
..press.the.
.button;
2..turn.the. Encoder knob until ‘ANI’ (menu 10) is displayed;
3..press. ;
4. rotate the Encoder knob and activate/deactivate the
function. ON = activated, OFF = deactivated;
5..push. .again;
6..press.twice. .to.exit..
To activate/deactivate the keypad beep, you can also use the
fast menu: press the
key and then .and.follow.the.
procedure.above.described.starting.from.point.3.
Repeater shift (for communications through
repeaters)
To select this function, follow these steps:
..press.the.
.button;
2..rotate.the. Encoder knob until ‘S-D’ (menu 19) is displayed;
3..press. ;
4. turn the Encoder knob and select the repeater shift. You
can.choose.amongst.the.following.options +, - and 0;
5..press. .again;
6..press.twice. .to.exit