MIDLAND Alan 42 multi - Manual (Page 13)

UK
13
HOW TO OPERATE WITH YOUR ALAN 42 MULTI
1. Insert the antenna in the antenna connector.
2. Insert the batteries into the battery compartment, noting polarity.
3. Rotate the ON/OFF volume control clockwise to turn the unit on. Adjust the
volume for a normal listening level.
4. Adjust the SQUELCH control
5. Select the desired channel by the UP/DOWN or QUICK UP/QUICK/DOWN but-
tons
Note: if the channel does not change,control that the EMG or LOCK button has not
been pressed. In this case, press the EMG or LOCK button to deactivate this fun-
ction.
As far as the other functions are concerned, refer to previous instructions.
To transmit: press and hold the PTT button, then talk to the microphone.
To receive: simply release the PTT button.
CAUTION: DON’T EXPOSE THE DISPLAY TO EXTREME TEMPERATURES.
FREQUENCY BAND SELECTION
The frequency bands must be chosen according to the country you are in.
Procedure:
1. Switch off the unit.
2. Turn it on while pushing the “A/F-LCR” and “SC” buttons.
3. By pushing the ▲ and ▼ buttons, select the desired frequency band (see the
chart here below).
4. To fix your selection, press the “A/F-LCR” button.
NOTE 1 : If you select a frequency band which operates in FM mode only, the “A/F-
LCR” control activates the LCR function (Last Channel Recall).
NOTE
2 : In the UK frequency band, you can select directly the EC band by pushing
the “AM/FM” button for 2 seconds.
FREQUENCY BAND CHART
Displayed digits Country
I Italy 40 CH AM/FM 4Watt
I2 Italy 34 CH AM/FM 4Watt
D Germany 80 CH FM 4Watt / 12 CH AM 1 Watt
D2 Germany 40 CH FM 4Watt / 12 CH AM 1 Watt
D3 Germany 80 CH FM 4Watt / 40 CH AM 1 Watt
D4 Germany 80 CH FM 4Watt / 40 CH AM 4 Watt
EU Europe 40 CH FM 4Watt / 40 CH AM 1 Watt
EC CEPT 40 CH FM 4Watt
E Spain 40 CH AM/FM 4Watt
F France 40 CH FM 4Watt / 40 CH AM 1 Watt
PL Poland 40 CH AM/FM 4Watt
UK England 40 CH FM 4Watt English frequencies
+ EC 40 CH FM 4Watt CEPT frequencies
ATTENTION!
The frequency band allowed all over Europe is 40CH FM 4W (EC) – See the
“Restrictions on the use” table.