Micromod MOD: 1726F Output holder for MOD 30ML - Manual (Page 6)

Using The Output Holder With MOD 30ML
Introduction
2
TECHNICAL SPECIFICATIONS
Output Holder Panel 1725F
Width - 19-inches (483-mm) Weight - 4 lbs. 9-1/2 oz. (2.08 kg) max.
Depth - 6-inches (153-mm) Panel Capacity - 6 Output Holders
Height - 3-1/2-inches (89-mm)
Output Holder Card 1726F
Analog Input
Span (0 to 100%) 4 to 20mA
Lower Limit 2.72mA
Upper Limit 21.28mA
Analog Output (I OUT)
Span (0 to 100%) 4 to 20mA
Lower Limit (-8%) 2.72mA
Upper Limit (+ 108%) 21.2BmA
Current Return (I RETURN)
Span (0 to 100%) 1 to 5mA
Lower Limit (- 8%) 0.68mA
Upper Limit (+ 108%) 5.32mA
Calibrated Accuracy (% of span)
I OUT, Run Mode (with respect to analog input) ± 0.5% max.
I OUT, Hold Mode (with respect to run mode analog input) ± 1.0% max.
I RETURN, Run Mode (with respect to analog input span) ± 0.7% max.
I RETURN, Hold Mode (with respect to run mode analog input span) ± 1.2% max.
Input/Output Characteristics
Analog Input Resistance 250 ohms typical
Analog Output (I OUT) Resistance 50k ohms min.
Open Circuit Output Voltage 24V dc max.
Output Ripple (100kHz) 1 % peak
Analog Output Load Capability
Resistance 800 ohms max.
Capacitance 10 uF max.
Inductance 10 H max.
Power Supply Requirements
Normal Operating Range 23V dc to 28V dc
Allowable Operating Range 16V dc to 28V dc
Allowable Ripple 1.0V P-P
Maximum Current 85mA dc
Environmental Requirements
Operating Temperature + 41°F (+ 5°C) to 122°F(50°C)
Physical Characteristics
Width 5-1/2-in. (140-mm)
Depth 4-3/8-in. (111-mm)
Height 13/16-in. (21-mm)
Weight 0.2 lbs. (85.5g)