Micromod MOD: 30ML and Modcell Totalization Application Guide - Manual (Page 21)

Using The Totalizer Block
Building the Strategy
19
39. At the bottom of the state table list add the following table.
ACTIOND, 8, "????????"
{
0, "NONE";
1, "RESET";
2, "STOP";
3, "RUN";
4, "HOLD";
}
Figure 7. State Table Data
40. Exit and save the state table list.
41. Close the State Table block by selecting .
Adding Communications
1. Select the Library icon.
2. From the library menu select Communications.
3. On the left side of the screen select the communications block required for the protocol being
used. Select either a Modbus or ICN block.
4. Place the block near the loop compound.
5. Open the block and set the slot location. For example: If you are using the on-board channel
of serial communications and are configuring the instrument from the front port the slot
location will be “On-board”.
6. Close the Communications block by clicking on .
7. Be sure there is a non-zero value in one of the scan groups found in the IF (Interface) block.
8. Compile the configuration and download it into the instrument.