Meriam M1500 Digital Pressure Transmitter - Manual (Page 8)

4
For For For For Digital Digital Digital Digital Communication Communication Communication Communication M1500s M1500s M1500s M1500s
Connect the M1500 to a host PC, using the RS-232, RS-485 or USB connections provided. See the “Digital Wiring
Diagrams” section of this manual for more details. Use the M1500 Meriam Setup Utility to configure the transmitter or
use MSP commands (see protocol documentation on the product CD or at
www.meriam.com under Resources /
Application Notes). The M1500 pressure default network address is 40 (0x28 Hex) and module address is 64 (0x40
Hex) for MSP and LabVIEW
®
. See the “Installation and Operation” section of this manual for additional information.
USB drivers must be installed on the host PC prior to communication with M1500 USB models. Find these drivers on
the product CD.
Interface Accessories Interface Accessories Interface Accessories Interface Accessories
The following table lists part numbers for various accessories available to assist in configuration or communication.
Part Number Description Accessory Status
Z9A000003PN06 M1500 Product CD ROM Standard, all models
Z9P273
USB type A to USB type mini-B cable–
used with analog output M1500s to
interface with PC & configuration software Optional for analog
models, initial set up
& support
Z7621-1
RS-232 to RS-485 Converter, PC Mount,
port powered
Optional for RS-485
models initial set up
& support
Z7621
RS-232 to RS-485 Converter, DIN rail
mount, externally powered Optional for RS-485
multi-drop networks
ZA900447-00052
DB-9 Cable, male x female – optional
accessory Option for RS-232
and RS-485 support
Z9R111
Meriam Serial Protocol Implementation
Guide On CD and available
at www.meriam.com
Mounting Options Mounting Options Mounting Options Mounting Options
M1500 mounting options include panel and DIN rail mount. Both are standard on all models and hardware is included
with shipment.
Panel mounting is achieved using the cut out and mounting hole guides below. Plan the mounting hole locations so
the P1 (HI) and P2 (LO) ports will be in the desired position upon completion. The four Port Manifold template is only
used for M1500-D I xxxx models with optional flushing ports.
Panel Mounting Template for 2 Port Manifold