Meriam M1500 Digital Pressure Transmitter User Manual
Page 2
2
Safety Information
Failure to follow all instructions could result in injury. Read, understand and follow all safety warnings
and instructions provided with this product. Also, meet or exceed your employer’s safety practices.
In no event shall Meriam be liable for any indirect, special, incidental, consequential or punitive damages or
for any lost profits arising out of or relating to any services provided by Meriam or its affiliates. It is not possible for
Meriam to identify all foreseeable uses/misuses, therefore all persons involved in commissioning, using or maintaining
this product must satisfy themselves that each intended application is acceptable.
Safety Warnings
The table below defines the safety symbols, signal words and corresponding safety messages used in the manual to
identify potential hazards and are intended to warn persons about hazards that could result in personal injury or
equipment damage.
This is the Read Instruction Manual symbol. This symbol indicates
that you must read the instruction manual.
This is the Safety Alert symbol. This symbol indicates a WARNING. Warnings alert you to actions that can cause personal
injury or pose a physical threat. Please read these carefully.
This is the Safety Glasses symbol. This symbol indicates that you must wear approved safety glasses during the task.
This is the Safety Gloves symbol. This symbol indicates that you must wear approved safety gloves during the task.
Indicates a potentially hazardous situation which, if not avoided, will result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
Indicates a potentially hazardous situation which, if not avoided, could result in minor or moderate injury.
Indicates information essential for proper product installation, operation or maintenance.
Information in this document is subject to change without notice. Check the Meriam web site (
www.meriam.com
) for latest
manual revision.
For customer assistance please call your local Meriam representative or Meriam directly.
Meriam Process Technologies
10920 Madison Avenue
Cleveland, Ohio 44102
Telephone: (216) 281-1100
Fax: (216) 281-0228
E-mail:
Web:
www.meriam.com
LabVIEW
®
is a registered trademark of National Instruments
Viton
®
is a registered trademark of DuPont