Installing with unixware, Installing with vmware, Installing with freebsd – Adaptec SAS/SATA/SCSI RAID Controllers User Manual
Page 47
Chapter 7: Installing the Driver and an Operating System
●
47
Installing with UnixWare
Note:
You will need your UnixWare Installation CD to complete this task.
To install the driver when installing UnixWare:
1
Insert the UnixWare Installation CD.
2
Restart your computer.
3
Follow the on-screen instructions to begin the UnixWare installation.
4
When prompted to load more HBA drivers, insert the driver disk, then select Yes. (To load
more HBA drivers, repeat this step.)
5
When all drivers have loaded, select No.
6
Complete the UnixWare installation, following the instructions included with your
operating system.
7
Continue with
Managing Your Storage Space on page 55
.
Installing with VMWare
Note:
You will need your VMWare Installation CD to complete this task.
To install the driver when installing VMWare:
1
Insert the VMWare Installation CD.
2
Restart your computer.
3
Follow the on-screen instructions to begin the VMWare installation.
Note:
The VMWare embedded driver will see the device and install.
4
Complete the VMWare installation, following the instructions included with your
operating system.
Note:
Currently, Adaptec Storage Manager is not supported on VMWare. To create and manage
arrays, use the
ARC
utility. See
for more information.
Installing with FreeBSD
Note:
You will need your FreeBSD Installation CD to complete this task.
To install the driver when installing FreeBSD:
1
Insert the FreeBSD Installation CD.
2
Restart your computer.
3
When the FreeBSD start screen opens, select 6 to escape to loader prompt.
4
Type
load kernel
.
5
Insert the driver floppy disk.
6
Type
load disk0:aacu.ko
.