MAX RB217 - Manual (Page 25)

25
4. Wire length adjustment
1 Be sure to turn the main switch OFF, to lock
the trigger and detach the battery pack.
2 The feed dial is a mechanism to adjust feed
rate of the Tie-Wire. When the edge part
length is not appropriate after binding, use
this dial to adjust it.
3 Mount the battery pack on the tool's main
body insert the charged battery pack on to
the main unit until a click is heard.
• When setting the main switch to ON, abso-
lutely do not bring your hand close to the
binding part or rotating part of the tip of the
tool.
4 Set the Trigger Lock to UNLOCK and turn on
the main switch.
5 Test the tool again to check the tie strength.
RB217
OFF
1 10
Edge part Edge part
Feed dial
WARNING