Maintain for performance, Storing, Trouble shooting/repairs – MAX HN75 User Manual
Page 13

5. MAINTAIN FOR PERFORMANCE
X DO NOT FIRE THE NAILER WHEN IT IS EMPTY
Y USE RECOMMENDED OIL
The velocite or turbine oil should be used to lubricate the tool. Upon
completion of operations, place 2 or 3 drops of oil into the air plug inlet with the
jet oiler. (Recommended Oil : ISO VG32)
Z INSPECT AND MAINTAIN DAILY OR BEFORE OPERATION
WARNING:
!
Disconnect air supply and empty the magazine when inspecting or
maintaining the tool.
(1) Drain air line filter and compressor
(2) Keep lubricator filled in air 3-pieces set
(3) Clean filter element of air 3-pieces set
(4) Tighten all screws
(5) Keep contact arm moving smoothly
6. STORING
X
When not in use for an extended period, apply a thin coat of the lubricant to the
steel parts to avoid rust.
Y
Do not store the tool in a cold weather environment. Keep the tool in a warm
area.
Z
When not in use, the tool should be stored in a warm and dry place. Keep out
of reach of children.
[
All quality tools will eventually require servicing or replacement of parts
because of wear from the normal use.
7. TROUBLE SHOOTING/REPAIRS
The troubleshooting and/or repairs shall be carried out only by the MAX CO.,
LTD.authorised distributors or by other specialists.
15