MAX HN75 - Manual (Page 12)

WHEN USING THE TOOL FOR STEEL PLATES
WARNING:
● Carry out work based on the required Work Standards.
● If there is no specified work standard, refer the following as a reference.
● Never use the nails for the ceilings (ceiling foundations included) or
roofs (roof foundations included).
● Be sure to apply discharge outlet to an object at a right angle.
● Do not drive the nails into the steel plate directly.
This tool is exclusively designed for 1.6 mm (1/16”) to 3.2 mm (1/8”) thick light gage steel.
When using it, comply with the Work Standards, considering the object condition and work site
environment.
Select appropriate nails according to the
object thickness, seeing the right table.
* The nails may not be driven into the object
depending on its hardness or thickness.
* If the object is thinner than an appropriate
range of thickness, the nails may not be
driven into it because of being bent.
Nail Selection Criteria
Diamete Length
Object
thickness
(Total) range
Light gage steel
thickness
2.5mm
(.099”)
45mm
(1-3/4”)
25 to 35mm
(1” to 1-3/8”)
1.6 to 2.3mm
(16 Gage to 13 Gage)
2.5mm
(.099”)
50mm
(2”)
25 to 40mm
(1” to 1-1/2”)
1.6 to 2.3mm
(16 Gage to 13 Gage)
2.5mm
(.099”)
57mm
(2-1/4”)
35 to 45mm
(1-3/8” to 1-3/4”)
1.6 to 2.3mm
(16 Gage to 13 Gage)
2.5mm
(.099”)
60mm
(2-3/8”)
40 to 55mm
(1-1/2” to 1-1/8”)
1.6 to 2.3mm
(16 Gage to 13 Gage)
If the thickness of the light gage steel foundations material used is
3.2 mm (1/8”), use the φ2.9 mm (113”) nails.
Never drive the nails directly into the light gage steel because they
will fly off, endangering you.
Be sure to apply the discharge outlet to the object at a right angle.
If applied obliquely, the nails will fly off, endangering you.
Never use the nails for the roofs (roof foundations included) or
ceilings (ceiling foundations included).
If the nails are driven into the steel plate too deeply, their holding
force will be extremely reduced. When working with the tool, fully
check the driven conditions.
Light gage steel:
1.6 mm (1/16”) to
3.2 mm (1/8”) thick
Object thickness
(Total )range
Wood
!
Penetration
amount
* For the 3.2 mm (1/8”) thick light
gage steel, use the φ 2.9 mm (.113”)
nails.
14