MAX HN65J - Manual (Page 9)

TEST OPERATION
X Adjust the air pressure at 170 p.s.i. (12 bar) and connect the air supply.
Y Without touching
Pull the Trigger. (Th
Z With the tool off the work-piece, pull the Trigger.
Then depress the Contact Arm against the work-piece.
(The tool must fire the fastener.)
[ Adjust the air pressure as much as the lowest possible according to the
diameters and length of fastener and the hardness of work-piece.
Th e
p cement easier, for instance on
f ntial Trip allows exact
fast fastener on recoil, as
des
acc r anything
se-while the operator is holding the trigger pulled.
the Trigger, depress the Contact Arm against the work-piece.
e tool must fire the fastener.)
MODEL IDENTIFICATION
SEQUENTIAL TRIP
e Sequential Trip requires the operator to hold the tool against the work befor
ulling the Trigger. This makes accurate fastener pla
raming, toe nailing and crating applications. The Seque
ener location without the possibility of driving a second
cribed under “Contact Trip”.
The Sequential Trip Tool has a positive safety advantage because it will not
identally drive a fastener if the tool is contacted against the work-o
el
SEQUENTIAL TRIP
Identified by ORANGE TRIGGER.
FIRE MECHANISM AND
EQUENTIAL TRIP)
For single fire opera act Arm against the work surface and pull
the Trigger. Tool can er is released and tool can
cycle.
SINGLE FIRE OPERATION (ANTI-DOUBLE
S
tion, depress the Cont
not fire a second nail until the Trigg
PROCEDURE
Depress the Contact Arm.
Pull the Trigger.
11