MAX TA551A/16-11 - Manual (Page 3)

3
OPERATING and MAINTENANCE MANUAL
INDEX
1. SAFETY INSTRUCTIONS
…………………………………………… 3
2. SPECIFICATIONS & TECHNICAL DATA ……………………………… 7
3. AIR SUPPLY AND CONNECTIONS …………………………………… 8
4. INSTRUCTIONS FOR OPERATION …………………………………… 10
5. MAINTAIN FOR PERFORMANCE …………………………………… 14
6. STORING ……………………………………………………………… 14
7. TROUBLESHOOTING/REPAIRS ……………………………………… 14
BEFORE USING THIS TOOL, STUDY THIS MANUAL TO ENSURE
SAFETY WARNING AND INSTRUCTIONS.
KEEP THESE INSTRUCTIONS WITH THE TOOL FOR FUTURE
REFERENCE.
1. SAFETY INSTRUCTIONS
TO AVOID SEVERE PERSONAL INJURY OR
PROPERTY DAMAGE
BEFORE USING THE TOOL, READ
CAREFULLY AND UNDERSTAND THE
FOLLOWING “SAFETY INSTRUCTIONS”.
FAILURE TO FOLLOW WARNINGS COULD
RESULT IN DEATH OR SERIOUS INJURY.
1. WEAR SAFETY GLASSES OR GOGGLES
Danger to the eyes always exists due to the
possibility of dust being blown up by the
exhausted air or of a fastener flying up due to
the improper handling of the tool. For these
reasons, safety glasses or goggles shall
always be worn when operating the tool.
The employer and/or user must ensure that
proper eye protection is worn. Eye protection
equipment must conform to the requirements
of the American National Standards Institute,
ANSI Z87.1 (Council Directive 89/686/EEC of
21 DEC. 1989) and provide both frontal and
side protection.
The employer is responsible to enforce the
use of eye protection equipment by the tool
operator and all other personnel in the work
area.
NOTE: Non-side shielded spectacles and
face shields alone do not provide adequate
protection.
ENGLISH
PRECAUTIONS ON USING THE TOOL
WARNING
WARNING