MAX TA551A/16-11 - Manual (Page 10)

ENGLISH
10
4. INSTRUCTIONS FOR
OPERATION
Read section titled “SAFETY
INSTRUCTIONS”.
1. BEFORE OPERATION
q Wear Safety Glasses or Goggles.
w Do not connect the air supply.
e Inspect screw tightness.
r Check operation of the contact arm & trigger if
moving smoothly.
t Connect the air supply.
y Check the air-leakage. (The Tool must not
have the air-leakage.)
u Hold the Tool with finger-off the trigger, then
push the contact arm against the work-piece.
(The tool must not operate.)
i Hold the Tool with contact arm free from work-
piece and pull the trigger. (The Tool must not
operate.)
o Disconnect the air supply.
2. OPERATION
Wear safety glasses or goggles danger to the
eyes always exists due to the possibility of dust
being blown up by the exhausted air or of a
fastener flying up due to the improper handling of
the tool. For these reasons, safety glasses or
goggles shall always be worn when operating the
tool.
The employer and/or user must ensure that
proper eye protection is worn. Eye protection
equipment must conform to the requirements of
the American National Standards Institute, ANSI
Z87.1 (Council Directive 89/686/EEC of 21 DEC.
1989) and provide both frontal and side
protection.
The employer is responsible to enforce the use of
eye protection equipment by the tool operator and
all other personnel in the work area.
NOTE: Non-side shielded spectacles and face
shields alone do not provide adequate protection.
Keep hands and body away from the discharge
outlet when driving the fasteners because of
dangerous of hitting the hands or body by
mistake.
Pusher
Magazine
Staples
STAPLE LOADING
q Pull pusher back into “locked” position.
w Insert the staples into the magazine.
WARNING
WARNING