Mallory Ignition ACCEL DFI 6A Electronic Ignition Control Module for Distributor Equipped Engines 75606 - Manual (Page 5)

5 ACCEL/DFI TECHNICAL SUPPORT 248.380.2780 www.accel-dfi.com
If Triggering With the Magnetic Pickup: (See Figure 7)
1. Make sure the ignition switch is in the OFF position.
2. Remove the coil wire from the distributor cap and set the terminal
approximately 1/4" from ground.
3. Disconnect the Ignition Control Module magnetic pickup wires from
the distributor.
4. Turn the ignition to the ON position. Do not crank the engine.
5. With a small jumper wire, short the Ignition Control Module green and
violet magnetic pickup wires together. Each time you break this short,
a spark should jump from the coil wire to ground. If spark is present,
the ignition is working properly. If there is no spark skip to Step 6
below.
6. If there is no spark.
A. Inspect all of the wiring.
B. Substitute another coil and repeat the test. If there is now spark,
the coil is at fault.
C. If there is still no spark, check to make sure there is 12 volts on
the small red/white wire from the Ignition Control Module when
the key is in the ON position. If 12 volts is not present, find
another switched 12 volts source and repeat the test.
D. If, after following the test procedures and inspecting all of the
wiring, there is still no spark, the Ignition Control Module is in
need of repair. See the Warranty and Service section for
information.
JUMPER WIRE
GREEN
VIOLET
FIGURE 7