Mallory Ignition Mallory MAGNETIC BREAKERLESS CONVERSION KIT 564R_564L - Manual (Page 2)

2
Step 7
Lubricate the distributor shaft and the top and bottom
of the thrust washer. A light coating of moly lube/
grease or similar lubricant is acceptable. Install the
reluctor sleeve and advance plate on the distributor
shaft. Install the felt pad into the top hole of the
reluctor sleeve.
Step 8
Install the advance weights and bushings. Install the
two E-clips. Install the advance springs.
Step 9
See Figure 3.
Install the module assembly into the housing. Make
sure that the cut-out in the plate is directly below the
hole in the housing where the wires will exit.
Step 10
Tighten the two nuts that hold the cap clips/brackets
in place. This also secures the module plate.
Marine Distributors Only
Replace the cap clips using the new aluminum pins
provided.
Step 11
Install the wire grommet. Lubricate the wires with light
oil. Run the wires through the grommet and out of the
distributor housing.
Step 12
Put the three wires into the female connector:
GREEN WIRE in hole #1
BROWN WIRE in hole #2
RED WIRE in hole #3
Plug the female connector into the distributor wire
harness. See Figure 3.
Step 13
Connect the three wires of the wire harness to the
correct locations as indicated in Figures 5 and 6.
Step 14
Set the pickup gap (see Figure 4).
Step 15
If the distributor was removed from the engine,
reinstall. Install the cap, rotor, and plug wires. Static
time the engine. Start the engine and recheck the
timing.
LEFT HAND ROTATION RIGHT HAND ROTATION
FIGURE 1
Insulators
Point Plate
Cap Clip
Nuts
Condensor
FIGURE 2
Advance Spring
E-Clip
Advance Plate
YH ADVANCE
Sleeve