Magnum Venus Plastech PVSensor - Manual (Page 6)

PVSensor Instruction Manual. Issue-08 25/06/2008 Page 6 of 8
APPENDIX A.2 - Retro-fit to Patriot SSB machines.
1. Connect the Feed Wires (leading from the PVS plug mounted on the chassis), to the Solenoid Socket as
shown, and making sure that the gasket is in place replace the socket cover using the central retaining
screw.
2. Screw the Machine Control solenoid assembly on to the underside of the Reset Button mounted on the side
of the chassis as per photo, using the M4 x 20 button head screw provided.
3. Using the 6mm clear nylon pipe, 6mm Tee and the 6mm stud provided, cut the 6mm pipe leading from the
MPG block to the MPG regulator as per the photo, insert the Tee and connect to the solenoid assembly
using the 6mm stud fitting.
4. Connect the Mounting Bracket on to the rear of the chassis, - making sure that the 2 x spacers are
positioned in between, and fix to the chassis using the 2 qty M5 x 16 button head screws provided.
5. Screw the PVS Electronic Module on to the top of the mounting bracket and connect the Module socket to
the machine mounted plug.
6. The PVSensor is now ready to set and connect to the mould.
APPENDIX A.3 - Retro-fit to Megaject SSB machines.
1. Follow the retro-fit instructions described for the Patriot SSB. You may find that the PVSensor plug was not
factory fitted on earlier machines, or the hole drilled. If this is the case then a PVSensor Plug # 5788 suitable
for a Megaject SSB will need to be ordered from your local Magnum Venus Plastech distributor to complete
the installation, and ask for further instructions if required.
Connecting the PVS to the
Patriot SSB
Sensor Plug
Tee into
6mm MPG
line Machine Control
Solenoid Assembly
2 x M5 Threaded
Mounting Inserts
Soleniod Socket
and
Feed Wire
Reset
Button
Power feed wires
Earth wire
Electrical connection
to the solenoid
socket