Magnum Venus Plastech CB-6000-GT Glass Monitor - Manual (Page 16)

CB-6000-GT Material Monitor Manual
Rev. 10/2012 Page | 16
Quick Start – Set Point:
The Digital Readout is designed to display the Glass Rate and Glass Total. After
counting up to a preset number of counts / weight the unit will then send a signal. This
signal can be used to turn OFF a resin pump and chopper or ON/OFF some other device.
FOR SYSTEMS WITH AUTOMATIC VALVING:
QUICK START: To Reset the Set Point Value
1. Plug the unit into a power source and turn the power switch to ON.
2. Locate the Glass Total readout unit, the lower left display.
3. The readout will display zero (0).
Note: Pressing the will exit the programming process with out saving.
4. Press the button this will display . The display will automatically
switch between the setting and
5. With the display showing press the or until is
displayed. Six times for F1 and four times for F2.
6. Press the button once, then press the or until is
displayed.
7. Now press the button six times until is displayed again. The
display will automatically switch between the set point number and .
Use the button to select the column and use the and to enter
the desired Set Point number.
8. To save the changes press the until is displayed.
SP - 1
0.0
PAR
PAR
Pro
Pro F1 F2
6 - SPt
PAR F1 F2 SP - 1
SP - 1
RST F1 F2
PAR END
Pro
DSP