Magnum Venus Plastech Pro Series 11:1 PRO PUMP VPRO-45110 - Manual (Page 5)

5
Introduction
This manual, the PRO PUMP MAINTENANCE & REPAIR MANUAL, provides information
you need to perform simple maintenance and repair on your equipment.
 Step-by-step assembly and disassembly procedures are included for each
component.
 A troubleshooting guide helps you diagnose and perform common repair
situations.
 A comprehensive maintenance schedule provides a detailed list for
performing daily, weekly, monthly, three-month and annual maintenance.
Please read the manual carefully. Follow the steps in the order given, otherwise you may
damage the equipment or injure yourself.
DANGER: Always wear proper safety equipment, including eye protection and gloves
when performing service and repair on this equipment.
During Disassembly:
As you disassemble the equipment, lay out the components in the correct order and
direction. This will help you to reassemble them.
Especially note the order of the piston cup (3101-12-1), piston cup spacer ring (3101-13-1),
piston cup backup ring (3101-14-1) and compression ring (15936-1) and the directions they
face. These directions are critical to proper functioning of this equipment.
Lubrication:
Throughout this manual, directions are given for lubricating various parts of the Pro Pump.
There are three types of lubricant used:
 If the part contacts resin, use MVP Red Grease (6706-2-1).
 If the part is located where it will contact air, use Lubriplate ® (08465).
 Throat Seal Oil (TSL-3200) used in the oil reservoir of the pump.
DANGER: FIRE AND EXPLOSION HAZARD. Never use any lubrication on the
components of the catalyst system. Contact your catalyst manufacturer for
additional material handing information.
CHAPTER
1