Magnum Venus Plastech UNIVERSAL PROPORTIONER - Manual (Page 3)

UPLS SYSTEM OVERVIEW
UP-XX-XX-XX
MAGNUM VENUS PLASTECH REV 1.00
APRIL 2010 PAGE 3
TABLE OF CONTENTS
CHAPTER 1-Introduction and General Information .................................................... 5
CHAPTER 2-Unit Information ....................................................................................... 7
FLUID SECTIONS CUBIC INCHES PER CYCLE AT 4”STROKE:........................................................ 7
FLUID SECTION RATIO RANGE BY VOLUME: .................................................................................. 7
MAXIMUM FLUID PRESSURE (2,500 TO 2,700 PSI) .......................................................................... 8
PRESSURE CONTROL VALVE .......................................................................................................... 8
AIR MOTORS (POWER HEADS) ........................................................................................................ 8
MIX/DISPENSE GUNS AND RECIRCULATION OPTIONS.................................................................. 9
MATERIALS A & B HOSE SETS FROM PUMP TO GUN..................................................................... 9
FLUSH SYSTEMS............................................................................................................................. 10
CHAPTER 3-Materials Information ............................................................................. 11
MATERIAL FEED .............................................................................................................................. 11
MATERIAL HANDLING ..................................................................................................................... 11
CHAPTER 4-Electrical Information ............................................................................ 13
CHAPTER 5-System Installation ................................................................................ 15
SYSTEM START-UP: ........................................................................................................................ 15
DAILY START-UP PROCEDURE ...................................................................................................... 19
DAILY SHUT-DOWN PROCEDURES ............................................................................................... 21