Magnum Venus Plastech PATRIOT 1:1 ADHESIVE SYSTEM - Manual (Page 19)

Patriot 1:1 Adhesive System Operations Manual
Rev. 09/2012 Page | 19
Priming the Unit:
Priming of Unit Air and Solvent:
1. Close the main inlet air valves on the main air manifolds (see fig. 6)
Figure 6
2. Connect 1/2 inch main air supply to the Air Manifold (see fig. 6)
3. Turn all regulators counterclockwise to full off and close all ball valves on the unit
4. Make sure Ram / Air lift control levers are in “neutral” (see fig. 7)
Figure 7
Connect the air supply to the
supplied fitting 1/2"npt.