beautypg.com

Unit requirements & assembly, Air requirements, Assemble the unit – Magnum Venus Plastech PATRIOT 1:1 ADHESIVE SYSTEM User Manual

Page 16

background image

Patriot 1:1 Adhesive System Operations Manual

Rev. 09/2012

Page | 16

Unit Requirements & Assembly:


Please make sure all appropriate personal protective equipment is used before start up of this unit. Refer
to and follow the requirements of the Material Safety Data Sheets supplied by your coating material
manufacturer for solvent, adhesive and activator.

CAUTION: Always wear proper safety equipment (glasses, gloves, respirator, etc.) when working
on the dispensing equipment.

Air Requirements:


1.

The system requires a supply of air (30cfm) and at least 100 psi.

2.

We require a 1/2" inch (12-13mm) inside diameter air hose minimum (Use caution when using quick
disconnects as they may restrict air flow.

3.

Preferably the air will be clean, dry and oil free.

Assemble the unit:


1.

Unpack and install the flush tank in the flush tank bracket (see figure 1 below).


2.

Unpack gun and hose set, inspect for damage.
















Yellow Solvent Tube to the Gun
Flush valve.

Flush Tank in bracket

Air supply to flush tank

Figure 1