Magnum Venus Plastech UltraMAX VLS-4600 Series - Manual (Page 22)

VLS-4600 Series Fluid Section Manual
Rev. 08/2013 Page | 22
SIX MONTH MAINTENANCE CHECKLIST:
PART PROCEDURE
Ai r Filter (“Water Trap”) Drain.
Hoses Check for kinks or leaks.
Gauges and Regulators Check for damage and proper operation.
Accumulator Remove and clean inside. Replace the O-Rings.
Danger: Never attempt to remove an accumulator
until you have relieved pressure. See Chapter 6:
Accumulator & Filter.
Filter Clean and inspect filter screen for plugging. Note:
Clean the screen weekly and when changing from
one material to another. Use proper screen mesh
size according to the material being used.
Fluid Section Replace the oil in the oil reservoir. If necessary, clean
and dry the silencers. Check piston rod, cylinder head,
piston and trip sleeve for wear and damage, replace as
needed. Replace O-Rings, cups, and packing set.
Check the pickup hose and wand for leaks and
damage. Check for packing leaks. Check piston rod
and pump cylinder for wear, replace as needed.
Replace the packing set, piston cups and O-Rings.
Catalyst Jug Check and clean tubes and filter screens if necessary.
Danger: Fire and explosion hazard. Never allow
solvent or grease to contact any part of the catalyst
system.
Air Lines Check for leaks, wear and kinks. Replace if necessary.
Catalyst Pump Replace all soft parts of the catalyst pump. Be sure to:
check bushings and pump cylinder and replace S.S.
balls, O-Rings, springs, piston seal and packing set.