Magnum Venus Plastech UltraMAX VLS-4600 Series - Manual (Page 18)

VLS-4600 Series Fluid Section Manual
Rev. 08/2013 Page | 18
 Seal Kits *
- DLS-4600-SS-RK Repair Kit – Stainless Steel Duo Units
- VLS- 46RK-4T-2T-SS Repair Kit – Stainless Steel fluid sections
- VLS-46-RK-4T-2T Repair Kit
– Standard fluid sections
- VLS-46RK-MP Repair Kit – Magnapak fluid sections
- UPLS-46SK-4T-2G Seal Kit – Standard fluid section
- UPLS-46SK-4T-1GB Seal Kit
– with optional Piston Seal
NOTE: Lubriplate® is a registered trademark of the Lubriplate division of Fiske Brothers
Refining Company.
NOTE: Loctite™ is a trademark of the Loctite Corporation.
NOTE: Teflon® is a registered trademark of E.I. DuPont de Nemours and Co.
IMPORTANT WARRANTY INFORMATION
Please note that components used on this equipment are made of specially developed, high-
strength material.
 Only authentic Magnum Venus Plastech replacement parts are acceptable for
use with this equipment.
 Use of unacceptable replacement parts will void our liability and warranty of this
equipment.
Please contact your Magnum Venus Plastech distributor for more information.
Installation & Set-up:
1.
Check all clamp brackets, pump column, slave arm bracket, manifold clamp, etc. to make
sure they will not move when unit is in operation.
2.
Check the mounting of catalyst pump to make sure clevis pins are secure.
3.
Make sure exhaust silencer is secured to the power cylinder of the resin pump.
IMPORTANT: Snug up the packing nut at the top of the catalyst pump approximately ¼
turn.
4.
Snug up, tighten, the resin pump packing by inserting two rods into the holes in the oil cup
at the top of the resin pump fluid section. Turn clockwise until packing is snug. Note: Do
not over tighten.