Impulse 7205e - Manual (Page 11)

Hardware Installation
Do not install the PCI Express board until the software
has been successfully installed.
The 7205e is shipped configured for RS-422 mode. If you intend to use RS-232 or
RS-485 modes, configure the adapter before installation.
Once you have installed the software, install the 7205e into an available PCI Express
slot and boot the computer. The drivers that were installed during the software
installation process will automatically be used to configure the adapter.
NOTE: Once the hardware installation begins, the Found New Hardware wizard
will appear three times – first for the parent multi-interface, and then two more
times for each serial port.
The following instructions are applicable to the Windows XP operating system and
may vary depending on your version of Windows.
1. After the software installation is complete, install the 7205e into an
available PCI Express slot and boot the computer.
2. A ‘Found New Hardware’ alert will appear above the system tray.
3. The ‘Found New Hardware Wizard’ will appear.
4. Choose ‘No, not this time’ and click ‘Next’ to proceed.
© Sealevel Systems, Inc. - 9 - COMM+2.LPCIe User Manual