Impulse 5102 - Manual (Page 7)

© Sealevel Systems, Inc. - 5 - ACB-MP.PCI User Manual
Technical Description
The ACB-MP.PCI utilizes the Zilog 85230 Enhanced Serial Communications
Controller (ESCC). This chip features programmable baud rate, data format and
interrupt control. Refer to the ESCC Users Manual for details on programming the
85230 ESCC chip.
Internal Baud Rate Generator
The baud rate of the ESCC is programmed under software control. The standard
oscillator supplied with the board is 7.3728 MHz. However, other oscillator values
can be substituted to achieve different baud rates.
Control and Status Registers Definition
The control and status registers occupy 16 consecutive I/O locations. The following
tables provide a functional description of the bit positions. X = do not care.
Base Mode D7 D6 D5 D4 D3 D2 D1 D0
+4 RD 0 IRQST 0 0 0 0 0 DSRA
+4 WR X X X 0 X X X X
+5 RD 485CLK ECHOA SYNCA_RTS SYNCA_CTS AM3 AM2 AM1 AM0
+5 WR 485CLK ECHOA SYNCA_RTS SYNCA_CTS AM3 AM2 AM1 AM0
+6 RD 0 0 0 0 RLA LLA TSETSLA RXCOPTA
+6 WR X X X X RLA LLA TSETSLA RXCOPTA
+14 RD SD7 SD6 SD5 SD4 SD3 SD2 SD1 SD0
+15 RD SD15 SD14 SD13 SD12 SD11 SD10 SD9 SD8
Field Description
IRQST
SCC interrupt status: 1 = No interrupt pending on ESCC 0 = Interrupt pending on ESCC.
DSRA DSRA: 1 = DSRA not active 0 = DSRA active
LLA Local Loopback: 1 = LL set 0 = LL not set
RLA Remote Loopback: 1 = RL set 0 = RL not set
TSETSLA TSET clock source: 1= Received TXC as source 0 = TRXCA as source
RXCOPTA RXCOPTA: 1= Selects SCC PCLK for RTXCA 0 = Selects received RXC for
RTXCA
SYNCA_RTS SYNCA _RTS: 1 = SYNCA connected to RTS 0 = SYNCA is high
SYNCA_CTS SYNCA_CTS: 1 = SYNCA connected to CTS 0 = SYNCA is high
485CLK TSET switches with TXD: 1 = clk switches 0 = no CLK switching
ECHOA ECHO enable: 1 = echo disabled 0 = echo enabled
AM0 – AM3 I/O mode select. See table for valid interface options. 0 = High Impedance
SD0 – SD15 Optional security feature. Unique value per customer or application. Default value = FFFF
Note: Default values are listed in bold