Impulse 3098 User Manual

Page 8

© Sealevel Systems, Inc.

- 6 -

REL-32 User Manual

Linux Installation

Note: You MUST have "root" privileges to install the software and drivers.

1. Login as "root".

2. Mount the CDROM by typing:

mount -t iso4860 /dev/hdc /cdrom

Note Your cdrom may not be /dev/hdc it could be /dev/hda, /dev/hdb, /dev/hdd, or if
you have a SCSI drive /dev/sda, /dev/sdb, /dev/sdc, etc. You may mount the
CDROM to any location, the /cdrom is just a common example.

3. Next change to the directory where you mounted the CDROM:

Ex. cd /cdrom/software/SeaIO/Other/linux

Note: The syntax is case sensitive.

4. Copy seaio .tar.gz to your home directory by typing:

cp seaio .tar.gz ~

5. Change to your home directory by typing:

6. Unmount the drive and then Unzip and Untar the drivers and software by

typing:

umount /cdrom

tar -xvzf seaio .tar.gz

7. Change to the SeaIO directory by typing:

cd SeaIO

8. Now compile and prepare the drivers for use:

make install

9. With the system off and unplugged, install your SeaIO PCI card.

10. Plug system back in and boot Linux.

11. Load the driver by typing:

SeaIO -load

The driver has enabled the card and is ready to use, and you now have the option to
run a test utility on it. Skip to section "Using the test software" if you wish to do so
at this time.

To set up Linux to automatically load the driver; refer to a Linux manual concerning
your specific distribution for help.