Impulse 3098 - Manual (Page 5)

© Sealevel Systems, Inc. - 3 - REL-32 User Manual
Card Setup
The REL-32 contains several jumper straps for each port that must be set for proper
operation.
Address Selection
The REL-32 occupies 4 consecutive I/O locations. The DIP-switch (SW1) is used to
set the base address for these locations. Be careful when selecting the base address
as some selections conflict with existing PC ports. The following table shows
several examples that usually do not cause a conflict.
Address Binary Switch Settings
1 2 3 4 5 6
280-283 000010 Off On Off On On On
288-28A 100010 Off On Off On Off On
2A0-2A3 010100 Off On Off Off Off On
328-32B 100101 Off Off On On On On
330-333 100110 Off Off On On Off On
Address Selection Table
The following illustration shows the correlation between the DIP-switch setting and
the address bits used to determine the base address. In the example below, address
300 is selected as the base address. Address 300 in binary is XXX 100000 XXX
where X = a non-selectable address bit and address bit A9 is always a 1.
DIP-Switch Illustration
Note: Setting the switch ‘On’ or ‘Closed’ corresponds to a ‘0’ in the address, while
leaving it ‘Off’ or ‘Open’ corresponds to a ‘1’.