Physical installation – Impulse 8018 User Manual
Page 8
© Sealevel Systems, Inc.
- 6 -
PIO-24.LPCI User Manual
Physical Installation
The adapter can be installed in any 3.3V or 5V Low Profile or PCI expansion slot.
Do not install the Adapter in the machine until the software has been fully installed.
1. Turn off PC power. Disconnect the power cord.
2. Remove the PC case cover.
3. Locate an available Low Profile or PCI slot and remove the blank metal slot
cover.
4. Carefully route the CA315 cable thru the opening in the bracket. Connect
each header to the card and secure the strain relief
5. Gently insert the PCI adapter into the slot. Make sure that the adapter is
seated properly.
6. Replace the screw you removed for the blank and use it to secure the adapter
into the slot. (This is required to ensure FCC Part 15 compliance.)
7. Replace the cover.
8. Connect the power cord
The PIO-24.LPCI is now ready for use.