Addonics Technologies JCCHDIS128 User Manual
Page 15
Addonics Technologies – Jupiter Cipher Combo Hard Drive User Guide v1.0 14
Optional Hardware
A. SATA Cartridge Cradle System
For Win98SE, Me, 2000 and XP
Note: There are no drivers needed to use the Serial ATA cable as long as the
drivers are installed for the Serial ATA Controller card/chip. It is plug and
play.
Hot Swap using Serial ATA connection is supported only on host controller
using Silicon Image chipset.
Disk Management for Windows 98
Note: Refer to the SATARAID Management Utility Manual
SATARAID Manual V1.30 (for non-RAID5 Controllers) found in the
Addonics Technologies website
B. USB 2.0/1.1 Cartridge Cradle System
Note: The Hot Swap feature for the above configurations is enabled by the
connection of the power cable connected to the 2-pin connector on the PCB
board on the cradle and the 2-pin connector on the IDE to SATA or IDE to
USB converter boards. With this feature you can remove the Jupiter Cipher
ExDrive from the cradle without shutting down the system.
SATA connector
IDE to SATA
converter
4-pin Molex
power connector
for PC power
supply
USB connector
IDE to USB2.0
converter
4-pin Molex
power connector
for PC power
supply
2-pin connector on the
IDE to SATA converter
board
2-pin connector on
the PCB board
2-pin connector on the
IDE to USB converter
board
2-pin connector on
the PCB board