Controlled Products Systems Group 9210-081 User Manual
Owner’s manual
Table of contents
Document Outline
- Section 1 – Installation
- Section 2 – Wiring
- Section 3 – Adjustments
- Section 4 – Operating Instructions
- Section 5 – Maintenance and Troubleshooting
- SECTION 1 - INSTALLATION
- SECTION 2 – WIRING
- SECTION 3 - ADJUSTMENTS
- 3.1 Circuit Board Adjustments
- Power LED indicates that low voltage power is applied to the circuit board. Input LEDs should be OFF and will only illuminate when the input is activated. The limit LED will be ON when the respective limit switch is activated.3.2 Switch Settings
- 3.2.1 SW 1 (Right Switch) Description and Function
- 3.2.2 SW 2 (Left Switch) Description and Function
- 3.3 Limit Adjustment
- 3.4 Reverse Adjustment
- 3.5 Speed Control (9220, 9230 Only)
- 3.6 Current Sensor Wiring
- SECTION 4 – OPERATING INSTRUCTIONS
- SECTION 5 – MAINTENANCE AND TROUBLESHOOTING