Controlled Products Systems Group 10441811 - Manual (Page 6)

Model 415 L LS 24V Swing Gate Operator
1. DESCRIPTION
2. DIMENSIONS
Built-in security and anti-crushing measures of the 415
Operator include built in reverse on contact and a torque
adjustment that controls the force transmitted to the gate leaf
through the 415 Operator.
The Manual Release mechanism is a key accessed device
that disengages (or engages) the cylinder on the 415 Opera-
tor. When the drive is disengaged, you can manually open
and close the gate leaf by hand.
Such manual operation of the gate is necessary during
installation and useful during prolonged power failures. The
torque of the 415 Operator is set using the Control Panel.
Reversing devices (such as inductive loops and photocells)
should be installed to provide non-contact reversing opera-
tion.
The 415 Operator automated system was designed and built
for controlling vehicle access. Avoid any other use what so
ever.
NOTES:
• Use suitable conduit to lay electric cables.
• To avoid any kind of interference, always use individual
sheaths to separate low-voltage accessories and control
cables from 115V~ power supply cables.
6 FAAC Model 415 L LS 24V Swing Gate Operator
Fig. 2
The FAAC 415 is an automatic gate operator for swinging
gate leafs. The 415 Operator is useful in residential applica-
tions and can accommodate gate leafs up to 14 ft long. The
self-contained 415 Operator consists of an electric motor
that drives a worm screw housed in an aluminum casing.
The locking provided by the 415 Operator (in the fully
opened and fully closed positions) is a service device rather
than a security device.
Also, for the protection and proper operation of the 415 Op-
erator, each operator has built in limit switches, so positive
stops are not needed.
Pos. Description
1 Operator
2 Release Device
3 Rod
4 Front Bracket
5 Rear Bracket
6 Rear Fitting
7 Rear Fitting Pin
8 Terminal Board Cover
Fig. 1
5¾ 4¼
37
* Measurements in Inches