Controlled Products Systems Group WKP5LM3 - Manual (Page 4)

4
Set-Up with Existing Network
Gate Access Panel (GAPLM) as Primary
Access Control Unit
Enter Master PIN Number on Keypad:
5 6
Enter Master PIN Number on GAPLM:
Then:
Then:
“BEEP” “BEEP”
Door Access Intercom (DAILM) as
Primary Access Control Unit
Enter Master PIN Number on Keypad:
5 6
Press and release the Learn button on the DAILM.
Keypad will beep twice indicating programming is
successful.
Then:
Keypad as Primary Access Control Unit
Step 1: On Secondary Keypad enter Master PIN
Number:
Step 2: Then: 5 6
NOTE: To switch a Secondary Keypad to a Main
Keypad, enter the Master PIN Number followed by
“57”.
Step 3: On Main Keypad enter Master PIN Number:
Step 4: Then: 0 5
NOTE: If a siren noise is heard the programming has
failed. Repeat process.
Programming Secondary Keypads to
additional Receivers (GCU or
ULTRX900R)
A Secondary Keypad defaults to activating
Receiver #2 when a PIN Number is entered on that
Keypad.
To activate Receiver #3:
Enter Master PIN Number on Keypad:
5 8 Then:
To activate Receiver #4:
Enter Master PIN Number on Keypad:
5 9 Then:
0 5
Pre-Installed Liftmaster
Receiver
Step 1: Pry open the front
panel of the receiver case
with a coin or a screwdriver.
Step 2: Press and release
the Learn button on the
receiver. The Indicator Light will
light for 30 seconds indicating that
receiver is in Learn Mode.
Step 3: Within 30 seconds enter Master PIN Number
on Keypad.
Step 4: Press “1”.
Repeat Steps 2-4 for each remote, or control device
that will be used to access the Liftmaster door or gate
operator.
Program
Erase All Control Codes
Press and hold the Learn button on the receiver until
the Indicator Light turns off indicating that the receiver
memory is clear (about 6 seconds).
12V
HIGH NORM
C
P2 M
Indicator Light
Learn Button