Codelocks Upgrade - Audit Trail Kit for CL5010 - Manual (Page 6)

6
ENTER NEW USER CODE
#
Master Code
•
01
•
User Code ID (e.g. 001)
•
New Code (e.g. 4321)
••
Result: New code 4321 entered at User Code ID 001.
(
•
when user enters code)
Note: ID positions 990 to 999 are reserved for One-Time User Codes.
SUSPEND USER CODE
#
Master Code
•
02
•
User Code ID (e.g. 001)
••
Result: User Code at ID 001 suspended.
(
• •
when user 001 enters code).
RESTORE USER CODE
#
Master Code
•
03
•
User Code ID (e.g. 001)
••
Result: User Code at ID 001 restored.
(
•
when user 001 enters code).
SUSPEND ALL USER CODE
#
Master Code
•
04
••
Result: All User Codes suspended.
(
• •
when user enters code).
RESTORE ALL USER CODES
#
Master Code
•
05
••
Result: All User Codes restored.
(
•
when all users enter code).
CHANGE UNLOCK TIME
#
Master Code
•
06
•
enter open time (range 2 - 9 secs)
••
Result: After code entry the lock will unlock for the set time.
(Factory pre-set time is 4 seconds).
ONE-TIME USER CODE
#
Master Code
•
07
•
One Time Code ID (e.g. 990)
•
One-Time Code (e.g. 5555)
••
Result: Code 5555 in position 990 will work once and then be
removed from memory.
Note: ID Positions 990 to 999 are reserved for this
program function, allowing up to 10 One-Time User Codes to
be entered.
* First change the factory Master Code #1234 – see Program 10.
Note: The Master Code and Sub-Master Code MUST always start with #. All codes must be the same length as the Master Code.
A
•
or
•
in the Key Sequence below indicates LED illumination. To use Audit Trail Function and programming via PC Program 16
must be active.
IF ENTERED, A SUB-MASTER CODE CAN BE USED INSTEAD OF THE MASTER CODE FOR ALL PROGRAMS EXCEPT
PROGRAMS 10,12,14,16,17,18 AND 19.
PROGRAM 01 PROGRAM 05
PROGRAM 02
PROGRAM 06
PROGRAM 07
PROGRAM 03
PROGRAM 04
PROGRAMMING