Codelocks Upgrade - Audit Trail Kit for CL5010 - Manual (Page 5)

5
3. Remove key from cylinder. Hold down the control pin in the
end of the cylinder and unscrew the cap.
4. Replace the tailpiece, hold down the control pin and screw
the cap fully on without tightening. Ensure control pin
projects to lock the cap.
5. Test the key operation. If the key is difficult to insert or tight
when turning, then the cap maybe too tight. Loosen the cap
one notch at a time and try the key again. If the key inserts
and turns OK, but is difficult to remove, then the cap may be
too loose. Tighten up the cap one notch at a time. Adjust the
cap until the key inserts, turns and removes easily.
6. With key turned 90º clockwise replace cylinder, cylinder
cover and handle.
CAUTION! DO NOT INSERT THE KEY IN THE CYLINDER
ONCE YOU HAVE REMOVED THE SCREW-CAP
3 4
5-6