Codelocks CL100 Surface Deadbolt - Manual

Surface Deadbolts
& Key Override Versions
Helpline, service & spares
FREEPHONE 0800 393 405
CODELOCKS LTD
Tel 01635 239645
Fax 01635 239644
[email protected]
www.codelocks.com
Remove the inside cover plate from the back plate, and
install the deadbolt according to the hand of your door.
Note that the standard bolt projects 40mm to the locking
side. A shorter bolt which projects 20mm is available.
Set the back plate with the knob in the vertical position and
hold it to the door with one end of the bolt against the frame
where the keeper will be fitted (see step 5).
Mark the position of the top fixing hole, and then using one
of the packing pieces as a template mark the position of the
lower fixing hole and the hole for the spindle.
Drill 8mm holes for fixing bolts and 13mm hole for spindle.
First select the appropriate keeper for your frame.
Position the keeper on the frame so that it lines up with the
deadbolt and mark the appropriate holes.
If you are using the Surface Keeper simply screw into place
(see fig. 5.1). Use the packing pieces as required.
The Mortice Keeper will require cutting a small recess
(see fig. 5.2).
Surface Keeper
fig. 5.1
Mortice Keeper
fig. 5.2
Note:
Establish which
keeper to use,
and mark its
position on the
frame, before
proceeding to
drill the door
for the lock
(see step 5).
Note:
Do not close the
door until you
are SURE that
the code works.
The spring loaded spindle will fit doors between 35mm and
65mm thick. For doors less than 50mm thick break off the
15mm section at the end of the spindle. For doors more
than 65mm thick ring the helpline for advice. The spring
keeps the spindle firmly engaged in the outside handle when
the lock is assembled on the door.
Cut the fixing bolts to suit the door thickness, allowing for
the rubber seals and at least one threaded section to screw
into the lock case.
Note that the bottom fixing bolt will be longer than the top.
Hold the lock case and the back plate, with the neoprene
seals in place, onto the door with the spindle in position.
Using the top fixing bolt first screw everything together.
INSTALLATION INSTRUCTIONS
II-1/200SD-V02
3. POSITIONING THE LOCK 4. FIXING THE LOCK 5. FITTING THE KEEPER