Codelocks Upgrade - Audit Trail Kit for CL5010 - Manual (Page 2)

CODES
• The factory set Master Code is #1234.
This should be changed immediately after installation (see
Program 10).
• The Master Code and optional Sub-Master Code always start
with the # prefix. This puts the lock into Programming Mode.
• When the Master or Sub-Master Code is entered 3 times
consecutively without performing a programming function,
a penalty time of 10 seconds is activated.
• The length of the Master Code determines the length of the
User Codes and the Sub-Master Code.
• If the Master Code is changed to another of the same length
then the Sub-Master and all User Codes will be retained.
• If the Master Code is changed to one of a different length
then the Sub-Master and all User Codes will be deleted.
• Codes may be 4, 5 or 6 digits long. The lock memory will
store 989 different User Codes, each identified by a User
Code ID - 001-989.
• The lock memory can store 10 different One Time User
Codes. Each One Time User Code is identified by a One
Time User Code ID - 990 to 999.
• If Program 16 is activated, User Codes can bet set
individually or as a group using Program 17 to enable the
lock to be opened only at specified times.
• When in Programming Mode a Program Code must be
entered within 5 seconds, otherwise the Red LED will flash
and BEEP and the lock will revert to normal.
• If a programming mistake is made wait 5 seconds, the Red
LED will flash and BEEP and the lock will revert to normal.
• A new code will be rejected if it is already in the memory.
OPERATING INSTRUCTIONS
The CL5000AT lock has a 12 button keypad including
✱
and # buttons.
AUDIT TRAIL FUNCTION
The CL5000AT has the ability to provide audit
information of lock activity; time lock opened, User Code
used etc. Once activated (Program 16) the same software
allows for easy programming of locks via a USB Stick
from a PC to the lock and from the lock back to the PC.
Multiple locks can be programmed in this way if required.
UNLOCK TIME
The factory pre-set UNLOCK time is 4 seconds. This may
be changed – (see Program 06).
PENALTY TIME
Entering 3 incorrect codes will cause the lock to suspend
activity for a penalty time of 10 seconds.
KEY OVER-RIDE
Turn the key clockwise 90º and depress the lever handle
to open the door.
CODE FREE MODE
Using the Master or the Sub-Master Code, Programs 08
and 09 will put the lock into, and out of, Code Free Mode.
In Code Free Mode battery power is not being used. If
Master and Sub-Master Codes cannot be issued for this
purpose it is possible to use the Key-in-Lever to put the
lock into Code Free Mode. This requires that the cylinder
tailpiece be changed according to the instruction on
pages 4 and 5.
CODES AND OPERATION