INTELLINET NETWORK NSC11-WN User Manual - Manual (Page 4)

4
- Increase the separation between the equipment and receiver
- Connect the equipment to an outlet on a different circuit than the receiver
- Consult your dealer or an experienced radio/TV technician for help
- Check that shielded (STP) network cables are being used with this unit to ensure
compliance with EMC standards
EU Countries Intended for Use
The ETSI version of this device is intended for home and office use in Austria,
Belgium, Denmark, Finland, France, Germany, Greece, Ireland, Italy, Luxembourg, the
Netherlands, Portugal, Spain, Sweden, and the United Kingdom.
The ETSI version of this device is also authorized for use in EFTA member states: Iceland,
Liechtenstein, Norway, and Switzerland.
EU Countries Not intended for use
None.
Important Information
1. Camera surveillance laws may differ for each country. Contact the local authorities to avoid any
surveillance law violations.
2. Note that the image sensor of this network camera can be damaged permanently if exposed to direct
sunlight. Defective image sensors that have been damaged by prolonged exposure to direct sunlight are
excluded from the product warranty.
3. Indoor network cameras are not weatherproof. Refer to the environmental specifications included in the
back of this manual. For outdoor use, use a weatherproof case to protect the camera from water,
moisture or temperature (higher or lower than specifications). To keep the camera clean, gently wipe it
with a clean, dry cloth.
4. Be sure to use only the DC adapter provided with your camera. If your network camera supports Power
over Ethernet (see the product information at the end of this user manual for details), you can use an
IEEE 802.3af-compliant PoE injector (mid- or endspan) to provide power to the camera.
5. Always handle the camera with care, as physical shocks can cause serious damage to the hardware.
6. Be sure to mount the camera securely to avoid any personal injuries. Keep the camera out of the reach
of children.
7. If the camera does not operate properly, contact your local distributor. Do not disassemble the product,
as that will void the warranty.
8. Technical product support is provided by your dealer or distributor via e-mail and phone. Additional
technical support is provided by INTELLINET NETWORK SOLUTIONS via the Web site
www.intellinet-network.com.
9. Before contacting technical support, be sure to verify that your camera has the latest firmware version
installed (you can access the camera’s system information page to find out). To expedite your technical
support request, it is recommended to include a very detailed error description in your message.
10. Should the camera not power up upon initial installation, you need to discontinue the use of the product
immediately.
11. Returns and replacements of defective products are handled by our network of authorized dealers.
Contact the place of purchase.
12. Used cameras, especially those that they were purchased on auction Web sites, are excluded from the
product warranty.