INSTEON Thermostat Adapter (2441V) Manual - Manual (Page 9)

Thermostat Adapter Owner’s Manual (Rev 2.0+)
Page 9 of 13
ADVANCED FEATURES
Restoring Power to Thermostat Adapter
Thermostat Adapter stores all of its settings, such as Links to other INSTEON devices, with non-volatile
memory. Because settings are saved in this non-volatile memory, they will not be lost in the event of a
power failure.
In the event of a power loss Thermostat Adapter will automatically return the load to the state it had
before power was interrupted.
Resetting Thermostat Adapter to its Factory Default Settings
The factory reset procedure can be used to clear the Thermostat Adapter memory of all INSTEON Links,
set points, etc.
1) If you are using a Controller to control Thermostat Adapter, be sure to Unlink it from the Controller.
See Unlinking Thermostat Adapter from an INSTEON Controller.
2) If you are using Thermostat Adapter to control any Responders, Unlink them from Thermostat
Adapter. See Unlinking an INSTEON Responder from Thermostat Adapter.
3) Unplug Thermostat Adapter from your thermostat
• Open the cover of the thermostat
• While pressing & holding the small round button (located on the bottom center of the
thermostat), gently pull down on Thermostat Adapter
The Thermostat Adapter Status LED will turn off
4) Wait 10 seconds
5) While pressing & holding the Set button on Thermostat Adapter, plug it back into your thermostat,
making sure not to let go of the Set button
6) Continue to hold the Set button for 3 seconds and then release
The Thermostat Adapter Status LED will stay off for about 20 seconds and then turn on
The thermostat display will flash all the LCD characters three times and then return to normal
operation
The Thermostat Adapter Status LED will flicker for a few moments and then turn on solid