INSTEON KeypadLinc Relay (2487S) Manual - Manual (Page 17)

Page 17 of 25 2487S - Rev: 1/21/2014 7:37 AM
ADVANCED FEATURES
Using KeypadLinc as a Phase Bridge ( Phase Bridging Detection Mode )
KeypadLinc automatically bridges the electrical phases in your home (via communications with dual-band
devices on the “other phase”). The following procedure to confirm that phases are bridged via
KeypadLinc:
1) Start Phase Bridging Detection Mode by tapping the Set button on KeypadLinc four times quickly
KeypadLinc will begin (Beeping)
KeypadLinc LEDs that are on will illuminate at full brightness
Other dual-band devices LEDs will illuminate at 100% brightness
2) Check the LED behavior of the “other” dual-band devices
- If the “other” dual-band device is blinking green
8
i. it is within range and not on the same phase, proceed to next Step
- If they are not blinking green
9
i. Try moving the “other” device, check other dual-band devices or begin
test from a different initiator
3) Tap KeypadLinc’s Set Button
KeypadLinc will stop beeping and LEDs return to previous state
Other devices’ LEDs will stop blinking
Add Multiple Scene Responders at Once
( also known as Multi-Linking Mode )
1) Set each of the Responders to the desired scene activation state
10
2) Tap the Scene controller button on KeypadLinc
3) Press and hold KeypadLinc’s Set Button until it beeps
KeypadLinc’s scene button’s LED will begin blinking
All illuminated LEDs on KeypadLinc will brighten to 100%
4) Tap KeypadLinc’s Set Button
KeypadLinc’s scene button’s LED will continue blinking
5) For each responder you are adding:
- Tap the responder button (if it is a multi-button device)
- Press and hold set button until it beeps (or, about 3 seconds until LED flashes)One at a
time, press and hold each of the Responder’s Set buttons for 3 seconds
6) Tap KeypadLinc’s Set Button
KeypadLinc’s scene button’s LED will stop blinking
KeypadLinc’s LEDs will return to normal brightness
7) Test scene by tapping the scene button a couple of times
8 Or is simply blinking for single colored LEDs. If the “other” dual-band device is a KeypadLinc Dual-Band, the 4 middle LEDs will blink.
9 Or are not blinking at all for single colored LEDs. If the “other” dual-band device is a KeypadLinc, any LEDs that are on will go to full bright.
10 For KeypadLinc buttons, tap the button until its LED is in the desired scene activation state