Hach-Lange DR 6000 User Manual User Manual
Dr 6000
Table of contents
Document Outline
- DR 6000
- Section 1 Technical data
- Section 2 General information
- Section 3 Installation
- Section 4 Startup
- Section 5 Standard programs
- 5.1 Overview
- 5.2 Instrument Setup
- 5.3 Save, recall, send and delete data
- 5.4 Stored Programs
- 5.4.1 Select a saved test/method; entering user-specific basic data
- 5.4.2 Stored programs options
- 5.4.3 Use of program timers
- 5.4.4 Set the dilution factor
- 5.4.5 Run a standard adjust
- 5.4.6 Set the chemical form
- 5.4.7 Run a reagent blank
- 5.4.8 To carry out a multiple determination
- 5.4.9 Selection of Reading Mode
- 5.4.10 Standard Addition - monitoring/checking results
- 5.4.11 Analysis of samples
- 5.4.12 Update/Program tests
- 5.4.13 Add stored programs to the favorite programs list
- 5.5 Barcode Programs
- Section 6 Expanded programs
- 6.1 User programs
- 6.2 Favorites
- 6.3 Single Wavelength (absorbance, concentration and transmittance readings)
- 6.4 Multi Wavelength mode – readings with more than one wavelength
- 6.5 Wavelength Scan mode – recording of absorbance and transmission spectrums
- 6.6 Time course of absorbance/transmittance
- 6.7 System Checks
- 6.8 Toolbar
- Section 7 Maintenance
- Section 8 Troubleshooting
- Section 9 Replacement parts
- Section 10 Contact
- Section 11 Warranty, liability and complaints
- Appendix A Help Guide
- Index