Hach-Lange DR 6000 User Manual - Manual (Page 17)

17
Installation
Figure 2 Back view
3.4 Power connections
1. Plug the power cable into the back of the instrument
( Figure 2, Page 17 ).
2. Insert the plug of the power cable into a grounded mains
socket (100–240 V~ / 50–60 Hz).
3. Switch the power button to "On" to turn on the instrument
( Figure 2, Page 17 ).
1 On/off switch 4 USB port type B
2 Socket for power cable 5 USB port type A
3 Ethernet port 6 Filter pad cover
N O T I C E
Use only a grounded socket for the connection of this device to the
power supply. If you are not sure if the sockets are grounded, have
this checked by a qualified electrician. The power plug serves in
addition to the power supply to isolate the device quickly from the
power source where necessary. During the disconnection from the
power source it must be made sure that the correct power plug is
pulled (for example by labeling the sockets). This is recommended for
long-term storage and can prevent potential dangers in the event of a
fault. Therefore make sure that the socket to which the device is
connected is easy to reach by each user at all times.
WA R N I N G
Electrical dangers and fire hazard.
Only use the supplied power cable.