Hach-Lange EVITA OXY User Manual - Manual (Page 25)

23
Setup menu
The setup menu is shown in an overview diagram
(fi g. 33) on page 24.
The setup menu consists of two parts:
• USC setup menu - for USC settings
• Transmitter setup menu - for transmitter settings
The setup menu is for commissioning and service
and for changing the settings. Access to the setup
menu is gained by pressing the key for 2
seconds. The setup menu will operate in two modes:
• View mode is a read only mode. The preselected
settings can only be scanned. The view mode is
accessed by pressing the key for 2 seconds.
Instead of keying in the password, press the
key. The factory setting of the password can be re-
established as follows:
• Switch off the power supply
• Press the key and switch on the power supply
• Release the key after 10 seconds
The password is now reset to 1000.
• Setup mode is a read and write mode. The pre-
selected settings can be scanned and changed. The
setup menu is accessed by pressing the key for
2 seconds and entering the password. The factory
set password is 1000, but can be changed to any
value between 1000 and 9999.