Hach-Lange SI792 P, SI792x P, SI792x P-FF, SI792x P-PA User Manual - Manual (Page 42)

Operation—4–20 mA/HART
40
5.2.3 Calibration mode configuration
An overview of the calibration setup menu is shown in Table 9 . Refer to
Appendix A on page 95 for buffer tables.
5.2.4 Alarm settings configuration
An overview of the alarm setup menu is shown in Table 10 .
Table 9 Calibration mode setup menu—CAL mnu
Select pH buffer set
CA.SOL
–01–BUF Knick/Mettler-Toledo
–02–BUF Merck Titrisols, Riedel Fixanals
–03–BUF Ciba (94)
–04–BUF NIST technical buffers
–05–BUF NIST standard buffers
–06–BUF (default) HACH buffers
–07–BUF WTW technical buffers
–08–BUF Hamilton Duracal
MAN (manual entry, for buffers not listed in this table)
DAT—Entry of offset and slope of premeasured electrodes
Enter calibration timer interval
CA.tiME
Enter the time interval for calibration (0 to 9999 hours; default: 0 h
to disable timer)
Table 10 Output setup menu for alarm settings
Select Sensocheck
AL.SnSO
CHECK ON Continuous Sensocheck evaluation of probe
function
CHECK OFF (default)
Enter alarm delay
AL.dLY 0010 sec (default) Range: 0000–0600 sec
LED in Hold mode
AL.LED
HOLD ON LED blinks during hold
HOLD OFF LED off during hold