beautypg.com

4 motor to base anchorage, English – CAME BX-241 User Manual

Page 5

background image

The following applications are only examples, as the space required for unit installation and the accessories vary de-

pending on dimensions and therefore it is up to the installer to select the best solution.

5.4 Motor to base anchorage

1- BX-241 unit

2- Control board incorporated

3- Radio

receiver

4- Limit-switch

tabs

5- Rack

6- Key-operated selector switch

7- Flashing light indicating door movement

8- Antenna

9- Safety

photocells

10- Photocell column

11- Closure stop

5

A

ll t

h

e d

at

a a

n

d i

n

fo

rm

at

io

n c

o

n

ta

in

ed h

er

ei

n

i

s c

o

n

si

d

er

ed

s

u

b

je

ct to c

h

an

g

e a

t a

n

y t

im

e a

n

d a

t o

u

r d

is

cr

et

io

n

ENGLISH

- Install the screws in the anchor plate and fasten them with a nut, then bend the preformed clamps downwards.
- Construct a cement foundation that is large enough to accomodate the gear motor (it is a good idea to protrude 50 mm. from the

ground). When pouring the foundation, embed the gear motor anchor plate and the relative clamps in the cement.

- The anchor bolts should be embedded in the concrete in the positions indicated; the drive unit is then attached to this bots. The

anchor plate must be perfectly level and absolutly clean; the bolts threads must be completly exposed.

N.B.: The fl exible tubes for the electrical wiring must be embedded in the base and protude in the correct position.

Fixing plate / Anchor stays

Cables

Concrete base

Rack-limit

Gate wing

Wall