Hydrotech PURA Ultimate 19-GU-PURA Operation Manual - Manual (Page 14)

14
10. Verify that the UV Lamp is working properly by looking for a faint blue glow underneath the silicon fitting on the
top of the UV Lamp.
11. Replace the top cover, the front panel and all hardware, including screws, which will prevent unsafe access by
untrained persons.
12. Taste the water. Check the unit is clean and functions to the customer’s satisfaction. If you are not satisfied
with the quality of the water, check the filters and flush additional water through the unit.
13. Prior to leaving the unit, educate the customer on the necessary steps for dispensing Hot, Cold & Room water
from the PURA Ultimate.
NOTE If an audible “click” is heard within 5 minutes of turning on the Red Power Switch, the hot tank is
likely empty, and has overheated. The overload device on the side of the hot tank will have to be
reset.
Once the power cord is removed, the reset button on the overload can be depressed by reaching your arm
and hand up from the bottom and up the side of the tank. This requires access through the lower front
panel of the Unit.
NOTE All personnel should be aware of company requirements for their own cleanliness and
hygiene when installing, servicing or sanitizing a unit
cAUTION! Resetting the hot tank requires the power cord to be removed!
Figure 5: Hot Water Reset
Hot Tank Reset