Hydrotech Precision-PWS 5-3 OWNERS GUIDE - Manual (Page 8)

STEP 5 STEAM STERILIZATION
This distiller has been factory tested. For this test, there is a white plastic tube installed in the
center of the charcoal filter cover. This tube is placed there so that we may properly test the
unit prior to shipping. You will also use this tube for steam sterilizing your unit. No.1 fill the
boiling tank 2/3 full with water. No.2 turn the power switch on and leave the fan and water
switch off. No.3 open the distiller water faucet so there is no build up of pressure in the
storage tank and run the distiller for 30-40 minutes. No.4 place the lid on the boiling tank. Shut
the unit off. It is normal for the distiller and water storage tank to get very hot. Allow the distiller
to cool for 1 hour and drain any water from the storage tank. Remove the drip tube and keep in
a safe place to be used later.
Corner Legs
Distiller Head
Cooling Coil
JG Elbow
Distiller Body
Outer Filter Housing
Leg
Adapter SS Tube
Water Storage Tank
Charcoal Canister
Sterilization Drip Tube
O-Ring
STEP
6 SWITCHES
There are three switches on your PWS 5-3 water distiller. The right switch is your power and
left is the cooling fan. By pressing the switches down they will be in the off position. The water
switch is located at the rear left side of the distiller. The water switch is in the on position when
the red side of the switch is showing.
04/08/04
8