GxT Ferret 31 Scan Tool - Manual (Page 8)

8 9
Readiness Status
Select Readiness Status from the
OBDII Session Menu and press
enter.
The status of all monitors, except the
comprehensive monitor is displayed.
The result of the comprehensive
monitor is displayed immediately
after the Scan Tool has successfully
connected to the vehicle controller.
A Value of “Pending” means that
particular monitor has not run. A
Value of “Done” means that particular
monitor has successfully completed
it’s test.
Accessing Additional Test Modes
Select Test Modes from the OBDII
Session Menu and press enter.
From the test mode screen you
can select O2 Sensor Tests, Non-
Continuous Tests, and Continuous
System Tests.
For additional information on each
test mode, consult the appropriate
section of the instruction manual.
Some vehicles do not support
additional test modes. If you select
one of the test modes listed here and
the Scan Tool does not report data within a few minutes, that test mode