Gardner Bender CP8006 Powered Cable Puller - Manual (Page 14)

5). The CP800 power head can be mounted to the CP601 frame in two ways. The position is
dependent on space constraints. See figure 7.
Capstan rotation is always clockwise (as viewed from end of capstan). If
power head is rotated, pull rope must always be wound from narrow end
toward wide end of capstan to prevent overlap.
Optional Mounting Position of CP800 Normal Mounting Position of CP800
8
Figure 6
Rope Conduit
CP800 CP601
Figure 7: In this position, the capstan rotates in the opposite direction; therefore, the rope must be wound in
the opposite direction.
Figure 7
Incorrect Setup Correct Setup